Chapter 4. Control Port Operation
62
November 2001
Press 1 to define a Line Code of HDB3, press 2 to define a Line
Code of AMI or press ESC. Press ESC to return to the Define E1
Line Parameter menu.
Press ESC again to return to the top of the Define System menu.
<< Define System Parameter >>
1. Timing
2. E1 Line
3. Time Slot
4. Data Port
5. Date & Time
Enter 1-5 or Press "ESC" to previous menu.
To enter the Timeslot Mapping menu, press 3.
<< Define Time Slot Mapping >>
1. Define Time Slot Mapping.
2. Send Time Slot to Far End.
Enter 1-2 or Press "ESC" to previous menu.
To define the Timeslot mapping assignments, press 1.
To Next Page
Loading...
