Chapter 4. Control Port Operation
69
November 2001
<< Remote Config Function >>
Controlled : OFF
1. OFF
2. ON
Enter 1-2 or Press "ESC" to previous menu.
Enter 1 to turn off remote control function (the connected remote
unit cannot change the timeslot mapping of this unit). Enter 2 to turn
on remote control (the connected remote unit can change the
mapping info of this unit). Press "ESC" to reach the Define System
Parameter menu and press 7 to setup the SNMP agent.
<< SNMP Agent Setup Menu >>
1. Set the Agent Information.
2. Set Access Control Table.
3. Set Trap Receivers Table.
4. Set Community String. < Public >
5. Save Parameter to SNMP Card and Exit.
Enter 1-5 or Press "ESC" to previous menu.
NOTE: The SNMP menu is not available if the optional SNMP card
is not installed in the ETU-01A.
To Next Page
Loading...
