Chapter 4. Control Port Operation
71
November 2001
<< SNMP Agent Setup Menu >>
1. Set the Agent Information.
2. Set Access Control Table.
3. Set Trap Receivers Table.
4. Set Community String. < Public >
5. Save Parameter to SNMP Card and Exit.
Enter 1-5 or Press "ESC" to previous menu.
Enter 2 to set the access control table.
<< Set Access Control Table >>
1. Input Agent IP Address. <0.0.0.0>
2. Input Access Permission. <Read Only>
Enter 1-2 or Press "ESC" to previous menu.
Enter 1 to set the input agent IP address (address of the
management workstation), 2 to set access permission for the
management workstation, or ESC to exit this menu. From the
SNMP agent setup menu, press 3.
<< Set Trap Receiver Table >>
1. Input Receiver IP. <0.0.0.0>
2. Input Severity. <Information>
Enter 1-2 or Press "ESC" to previous menu.
Enter 1 to set IP address of the input agent to receive traps sent by
the ETU-01A. Enter 2 to set the severity of traps sent;
informational, warning, or severe.
To Next Page
Loading...
