CTC Union ETU-01A - Page 82

Chapter 4. Control Port Operation
76
November 2001
If we now ESC back, the display of all loop back status can be
observed. Note that the E1 Line is now set for Local Analog Loop
Back.
<< Define LoopBack Test Port >>
E1 Line Loopback : LOCAL ANALOG
Data Port LoopBack : LOOPBACK OFF
1. E1 Line
2. Data Port
Enter 1-2 or Press "ESC" to previous menu.
Now we will select the E1 Line again (Press 1) and turn OFF loop
back (by pressing 1).
<< E1 Line LoopBack >>
E1 Line LoopBack : LOOPBACK OFF
1. OFF
2. Local Analog
3. Local Digital
4. Local Payload
5. Remote Analog
6. Remote Payload
Enter 1-6 or Press "ESC" to previous menu.