CTC Union SHDTU03 - Configure E1 Parameters

Chapter 5. Configure via Console Port
5-16
follow the rule:
RULE
First Time Slot ? 30 - Time Slot Number
First Time Slot ? 30 - Time Slot Number
Unframed E1
Data Data Data Data Data Data Data Data Data Data Data
0 1 2 3 4 5 6 7
8 31
Time Slot
64k 64k 64k 64k 64k 64k 64k 64k 64k 64k1408k
9 ~ 30
Configure EI parameters
This section introduce the setting of E1 code, frame, rai, built out and
e_bit. Select E1 and press [ENTER] or [RIGHT].
-----------------------------------------------------------
type Configure shdsl type
shdsl Configure shdsl parameters
>> e1 Setup e1 parameters
default Restore factory default setting
-----------------------------------------------------------
>> code Configure e1 code
frame Configure e1 frame
rai Configure e1 rai
build_outs Configure e1 build outs
e_bit Configure e1 e_bit
For configuring code, move the cursor to code and press [ENTER]. Select
the parameter via [TAB] key.
-----------------------------------------------------------