CTC Union SHDTU03 - Upgrade the SHDSL NTU

Chapter 5. Configure via Console Port
5-28
XI. Upgrade the SHDSL NTU
This section will introduce how to upgrade the kernel and FPGA of the
SHDSL NTU. Select upgrade in main menu and press [ENTER] or [RIGHT].
------------------------------------------------------------
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot the system
diag Diagnostic utility
admin Setup management features
>> upgrade Software upgrade
exit Quick system
------------------------------------------------------------
Before upgrading the NTU you must have the main software or FPGA
code in your computer.
If you want to upgrade the kernel:
1. Select kernel and press [ENTER] or [RIGHT].
-----------------------------------------------------------
>> kernel Upgrade main software
FPGA Upgrade FPGA code
-----------------------------------------------------------
2. Confirm the process via pressing “y”
-----------------------------------------------------------
Command: upgrade kernel <CR>
Message: Please input the following information.
Are you sure (y/n)?: (Note: this will erase flash) y
---------------------------------------------------------------------