Chapter 5. Configure via Console Port
5-29
3. After entering “y”, the SMT will show
------------------------------------------------------------
Utility running window...
Starting XModem download...CCC
------------------------------------------------------------
4. Click Send file in terminal access program, hyper terminal, to send the
file.
5. Select the source file in window and press OK.
6. After upgrading the product, press “y” to write in flash.
If you want to upgrade the FPGA code:
1. Select FPGA and press [ENTER] or [RIGHT].
-----------------------------------------------------------
kernel
Upgrade main software
>> FPGA Upgrade FPGA code
------------------------------------------------------------
Command: upgrade FPGA <CR>
Message: Please input the following information.
Are you sure (y/n)?: (Note: this will erase flash) y
------------------------------------------------------------
2. After entering “y”, the SMT will show
------------------------------------------------------------
Utility running window...
Starting XModem download...CCC
---------------------------------------------------------
To Next Page
Loading...
