Chapter 5. Configure via Console Port
5-31
XII. Diagnostic
The diagnostic facility allows you to test the different aspects of your
SHDSL NTU to determine if it is working properly. Select diag and press
[ENTER] or [RIGHT].
------------------------------------------------------------
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot the system
>> diag Diagnostic utility
admin Setup management features
upgrade Software upgrade
exit Quick system
------------------------------------------------------------
Loopback can test whether the NTU is properly working with the connected
device.
Press [ENTER] or [RIGNT] to setup the loopback.
-----------------------------------------------------------
>>
loopback Loopback
ber_test Ber_test
--------------------------------------------------
Command: loopback
<...local|remote_line|remote_payload|Farend_line|Farend_pa
yload>
Message: Please input the following information.
SHDSL Loopback Type (TAB Select) <disable>:
e1_line
---------------------------------------------------------------------
To Next Page
Loading...