CTC Union SHDTU03 - Reboot the SHDSL NTU

Chapter 5. Configure via Console Port
5-24
VIII. Reboot the SHDSL NTU
For the SHDSL NTU to work with new parameters, you must reboot it
after writing the parameters into NVRAM. Follow the procedure;
Step 1: In main menu, move the cursor to reboot and press [ENTER].
--------------------------------------------------------------
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
>> reboot Reset and boot the system
diag Diagnostic utility
admin Setup management features
upgrade Software upgrade
exit Quick system
--------------------------------------------------------------
Step 2: Type “y” to reboot the SHDSL NTU.
---------------------------------------------------------------
Command: reboot <CR>
Message: Please input the following information.
Do you want to reboot? (y/n): y
---------------------------------------------------------