4. Handling and Transport
Before moving the unit, check that it is stable (check that the support surface is horizontal).
Before moving the unit, it is advisable to remove the parts installed after delivery in order to prevent damage
(see the Chapter Installation).
During this phase, it is recommended to:
- Correctly position all the accessories provided to prevent them from falling or being damaged during transport
- Move slowly and carefully to prevent possible instability
- Keep an adequate distance.
Be particularly careful when handling the unit in the workplace. In particular, avoid dips, steps or similar. If you
are not careful during transport, the adjustments made may not be correctly calibrated.
To transport the unit, use the wheels on the base
and push the unit by hand. Move only on at
surfaces.
To handle the unit, all the wheels must
touch the ground to prevent sideways lifting.
To lift the unit, use a lift truck of adequate capacity
for the weight of the unit (indicated in the technical
specications) using the pallet as support base.
To Next Page
Loading...