EasyManua.ls Logo

CTR ASTRA - 2. Technical Features

CTR ASTRA
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruction Booklet
9
ENGLISH
ASTRA • ASTRA PLUS
Recharge to vehicle: the regenerated refrigerant can be recycled (after adding virgin oil) according to the methods provided
for by the operator. You can also fill the system with new refrigerant fluid, new oil and UV tracer in the desired quantity.
Recharge cylinder: this function is used to fill the internal cylinder controlled by an electronic process.
Automatic cycle: performs the sequence of all the operations to restore the system with the correct levels of refrigerant and
oil without the help of an operator.
Do not use the unit for purposes different from those for which it was designed. In the event of scrapping, comply
with the regulations in force in the country where this operation is carried out (bear in mind that the unit contains
refrigerant fluids; contact specialised companies for scrapping/demolition).
The unit must be used with the type of refrigerant indicated on the CE label. Do not use it with refrigerants other
than the indicated type.
2. Technical features
In order to better represent the technical specifications, they have been broken down by model.
Description
Unit of
Measure
Astra
AstraPlus
Maximum power absorbed W 900 900
Net weight Kg 68 74
Overall dimensions (HxWXD) cm 104x48x58 104X48X58
Weight with full charge kg 78 92
Vacuum pump flow rate l/min 72 142
Final vacuum mbar 0.1 0.01
System recovery capacity gr/min 400 400
Refrigerant cylinder capacity l 12 19
Power supply voltage V 220/240 220/240
Power supply frequency Hz 50 50
Maximum current absorbed A 4 4
Coupling diameter on vehicle (Low Pressure - LP) mm 11 11
Coupling diameter on vehicle (High Pressure - HP) mm 16 16
Maximum operating temperature °C 50 50
Minimum operating temperature °C 5 5
Maximum pneumatic circuit pressure bar 16 16
For the connection voltage value, follow the instructions found on the label on the unit.
The acoustic pressure value measured is less than 70dBA and therefore the operator does not need to take any particular protection
measures even if continually using the unit (ISO 3746). Nonetheless, the employer is responsible for assessing the level of noise the
workers are exposed to in accordance with the regulations in force regarding hygiene and safety in the workplace.