INSTRUMENTS/CONTROLS
31
4. MID PTO CONTROL LEVER (IF EQUIPPED)
Move the lever forward to
engage the Mid PTO. Move the lever
rearward to disengage the Mid PTO.
NOTE: Be sure the Mid PTO
control lever is in OFF slot when
starting the engine.
NOTE:
1. The Rear and Mid PTO shaft can be operated at the same time.
2. When not using the Mid PTO shaft, cover the shaft with the Mid PTO cover.
PTO SWITCH
PTO switch is used to engage or
disengage the Independent PTO
clutch. Turn right to engage push
to disengage.
(stop the turning of PTO shaft)
PTO indicator lamp in the meter
panel is illuminating when PTO is
in ON position.
PTO indicator lamp is not illuminating
when PTO is in OFF position.
NOTE: Be sure the PTO switch is
in OFF position when starting the
engine.
To Next Page
Loading...
Need help?
General