OPERATING INSTRUCTION
NORMAL STARTING PROCEDURE
IMPORTANT: It is very important that enough lubricant reaches the engine
parts before operating the engine at rated speed.
38
Operate controls only when seated in the operators seat.
Engine can start with transmission in gear when neutral or safety
start switch is by-passed:
1. Do not connect across terminals on starter.
2. Attach a booster battery by connecting the positive terminal of
the booster battery to the “positive terminal” provided or to the
positive terminal of the machine battery. Connect the negative
terminal of the booster battery to the “negative terminal” provided
or to the chassis of the machine.
Then use recommended starting procedures from operators seat.
3. When necessary, repair electrical system components promptly
so that “jump starting” will not be attempted.
Machine run-away can cause injury or death to operator and
bystanders.
Before starting the engine, be sure all operating controls are in
neutral or park lock position. This will eliminate accidental
movement of the machine or start up of power driven equipment.
STEP 1
Make sure the fuel shut-off valve
is open. The valve is located at the
bottom RH side of the fuel tank.
STEP 2
Put the gear shift lever in the
Neutral position (Gear Drive) or
the Speed Lock Lever to be released
(Hydrostatic Drive).
FUEL SHUT-OFF VALVE
FUEL SHUT-OFF VALVE
NEUTRAL
POSITION
OPEN
To Next Page
Loading...
Need help?
General