OPERATING INSTRUCTION
39
STEP 3
STEP 5
Put the REAR PTO and MID PTO
control levers in the OFF
(Engine start) position.
Put the engine speed control lever
at the middle position.
STEP 4
Put the SHUTTLE lever in the N
(Engine start) slot (Gear Drive).
STEP 6
Turn the starter key switch to the
heat & ON position.
Wait until the glow plug indicator lamp
is put out.
(Approximately 1 to 3 seconds.)
HST control pedal in the N position
CLUTCH pedal (HST Drive)
OFF
POSITION
OFF
POSITION
ENGINE
SPEED
CONTROL
LEVER
ENGINE
SPEED
CONTROL
LEVER
To Next Page
Loading...
