2 Cautionary Items at Operation
16
2.2.1 Wire
1. Tighten the wiring terminal securely.
2. Repair or change the damaged or deteriorated wire
immediately.
3. Clamp securely and take caution not to damage the
wire by clamping.
4. Take caution not to have the wire contact with
dangerous part (rotating equipment, exhaust box,
and corner with acute angle, etc.).
5. Set the grommet securely and take caution not to
damage the wire.
6. Clamp the wire with no slack, twist, or forced
pulling. However, it may require some slacks in
moving part.
7. Take caution not to pinch the wire when installing
the parts.
8. Connect the battery only after rechecking the
terminal protection or clamp condition, etc. after
wiring.
9. Use the fuse with specified capacity. It is strictly
prohibited to substitute the metal wire or copper
wire for the fuse.
2.2.2 Battery
1. Do not install the battery with capacity other than
specified (Ah).
2. Apply some grease to the battery terminal after
connecting the cable and cover with terminal cover.
3. Take caution not to accumulate the refuse or dust on
the battery.
4. Remove the battery from the vehicle when charging
the battery.
2.2.3 Coupler
1. When disconnecting the coupler and plug terminal,
take caution not to pull the harness.
2. Press the lock and pull to disconnect the CN
coupler and PA coupler.
GS7W1-006
GS7W1-007
(CN Coupler) (PA Coupler)
Lock
Male terminal side Female terminal side
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General