Cub Cadet Challenger 700 Operator's Manual

5-12 Pre Operation Checks
Set pressure with tires cold. Set tire pressures
to the following specifications:
Recommended
Pressure
Minimum Maximum
Front
10psi (70kpa
(0.70kgf/ cm
2
)
9 psi (63kpa,
0.64kgf/ cm
2
)
11 psi, (77kpa,
0.77kgf/
cm
2
)
Rear
10psi (70kpa
(0.70kgf/ cm
2
)
9 psi (63kpa,
0.64kgf/ cm
2
)
11 psi, (77kpa,
0.77kgf/ cm
2
)
How to measure tire pressure
Use the tire pressure gauge.
NOTE:
The tire pressure gauge is included as standard
equipment. Make two measurements of the tire
pressure and use the second reading. Dust or
dirt in the gauge could cause the first reading to
be incorrect.
1. Tire pressure gauge
5. Use no more than the following pressures
when seating the tire beads.
Front 36psi (250kpa, 2.5kgf/cm
2
)
Rear 36psi (250kpa, 2.5kgf/cm
2
)
Higher pressures may cause the tire to burst.
Inflate the tires very slowly and carefully. Fast
inflation could cause the tire to burst.

Cub Cadet Challenger 700 Specifications

General

Brand	Cub Cadet
Model	Challenger 700
Category	Utility Vehicle
Language	English