14-14
14. PERIODIC SERVICE
Sc2400 Operator’s Manual
2. Parking Brake Safety Switch
1. Disengage the parking brake.
2. Turn the key to the START position.
3. Make sure that the starter motor does not crank.
4. Turn the key to the OFF position.
5. Engage the parking brake securely.
6. Turn the key to the START position.
7. Make sure that the starter motor starts running.
3. Drive Pedal Safety Switch
1. Turn the key to the START position to run the
engine.
2. Pull up the Power Take Off (PTO) switch to set it
to the ON position.
3. Disengage the parking brake.
4. Slowly step on the reverse side of the forward and
reverse drive pedal.
5. Make sure that the PTO is not running.
4. Drive Pedal and Seat Safety Switch
1. Turn the key to the START position to run the
engine.
2. Make sure that the Power Take Off (PTO) switch
is in the OFF position.
3. Raise up slightly off the seat (Do not get off the
machine).
4. Slowly step on the drive pedal.
5. Make sure that the engine stops after around one
second.
5. Seat Safety Switch
1. Turn the key to the START position to run the
engine.
2. Pull up the Power Take Off (PTO) switch to set it
to the ON position.
3. Raise up slightly off the seat (Do not get off the
machine).
4. Make sure that the engine stops after around one
second.
To Next Page
Loading...
Need help?
General