8-4
8. OPERATE THE TRACTOR
Sc2400 Operator’s Manual
4. Use the range gear lever and the 4-
wheel drive lever to select the travel
speed.
(A) Range gear lever
(a) SLOW : Used for heavy-load operation.
Low traveling speed.
(b) FAST : Used for light-load operation.
High traveling speed.
(B) 4-wheel drive lever
(c) 4-wheel drive mode
(d) 2-wheel drive mode
IMPORTANT: Avoid damage.
●ALWAYS keep the 4-wheel drive lever in the 2-
wheel drive mode when traveling on a paved
surface.
●ALWAYS disengage the 4-wheel drive lever put in
the 2-wheel drive mode when not needed to
prevent premature wear of the front tires.
●NEVER install tire chains to the front wheels.
Chains will hit and can damage the tractor.
●If disengaging the 4-wheel drive lever is difficult,
stop the tractor, turn the steering wheel right and
left several times. Then attempt to disengage the
4-wheel drive lever again.
●To minimize tire wear, drive in the 4-wheel drive
mode only when absolutely necessary. Driving the
tractor on a paved road in the 4-wheel drive mode
can accelerate wear of the tires.
●To obtain better traction, keep the front tires at the
maximum allowable pressure.
●When the 4-wheel drive lever is in the 4-wheel
drive mode, braking will apply to all four wheels.
5. Adjust the throttle control lever to
attain an intended speed.
(A) Throttle control lever
(a) To increase the engine speed:
pull the throttle control lever backward.
(b) To decrease the engine speed:
push the throttle control lever forward.
3014919a
(A)
(a)
(b)
3014904b
(B)
(d)
(c)
3014903e
(A)
(b)
(a)
To Next Page
Loading...
Need help?
General