Cub Cadet XR2 1000 - F. How to Wire a Separated Zone

34 35
10cm [4in]
28cm
[11in]
Main Zone
Sub Zone
Two wires
under
same peg
50cm [20in]
Min 50cm (20in)
Min 50cm (20in)
50cm [20in]
• If a Narrow Pass is shorter than 2 m [7 ft], set up only one
square Perimeter Island in the passage
• Take care to wire Narrow Passes correctly to ensure that the
mower doesn’t cross into dierent zones spontaneously while
mowing
Narrow Passes should be rm, level, and smooth.
TIPS
A helpful video
is available
online
Two wires
under
same peg
Base Station
Separated Zone smaller than
100m
2
(1100ft
2
)
OPTION 1
Extend the Perimeter Wire from the Main Zone,
over the obstacle.
F. How to Wire a Separated Zone
Don’t have a Separated Zone?
Skip this section!
Type C / Type D
If your Separated Zone is larger than 100 m
2
/ 1100 ft
2
,
your mower won’t be able to nish it in a single operation.
Therefore, it is recommended to wire it separately and connect
it to its own Base Station.
If your Separated Zone is smaller than 100 m
2
/ 1100 ft
2
, you
can wire it in one of two ways.