Cub Cadet XR2 1000 - G. Complete Wire Setup

36 37
OPTION 2
Wire the Zone separately and connect it to a Perimeter Switch
(optional accessory).
Perimeter
Switch
Separated Zone smaller than
100m
2
(1100ft
2
)
Main Zone
Power Supply
and Base Station
Once the Perimeter Wire has been laid completely, the two ends of
the wire that meet at the Base Station should be joined together.
G. Complete Wire Setup
• Use the same peg to fasten both tail ends of the wire
to the ground
• Trim the ends so both wires are the same length
TIPS
Make sure you twist the two wires together properly.