Cub Cadet XR2 1000 - A. Connect the Power Supply Unit

40 41
Insert only two stakes
into the Base Station
holes as shown.
Connect the green connector of the perimeter wire to the Base
Station as shown below, while keeping the right polarity.
Be careful not to damage irrigation pipes when hammering
down the stakes.
Make sure the connector is inserted the whole way
up to the white mark.
Connect the DC cable from the Power Supply unit to the 15
m (50 ft) power cord.
Consider the following
in order to select a proper
location for the Power
Supply unit:
A. Connect the Power Supply Unit
• Select a suitable location
near a power outlet
• Position it outside the lawn
perimeter
• A dry and sheltered
location is preferable
TIP
Power
Supply unit
Base
Station
15 m (50 ft)
Power Cord [low
voltage]