42 43
Connect the Power Supply unit to a regular power outlet.
LED indication
WHAT YOU’LL NEED:
• The mower
• Remaining Pegs
• Remaining Base Station stakes
A. Start up
There are a few things to do before your mower can start.
Ready, Set,
Test
1. Adjust the mowing height
(36-83 mm/1.4-3.25 in) by
turning the cutting height
adjustment knob:
• To raise the cutting height,
turn clockwise.
• To lower the cutting height,
turn anticlockwise
• The cutting height is displayed
at the side of the mower.
Prepare your mower and give it a test drive.
LOW HIGH
Operating
panel
Safety
Switch
Cutting Height
Indicator
Now you should see the LED indication on the Base Station
blinking green (if the mower is outside, or steady green (if the
mower is inside the Base Station).
The Power Cord from the Power Supply to the
Base
Station should be securely fastened to the ground! It
should never present a tripping hazard.
The Power Cord should cross ONLY over soft
surfaces.
It should not cross over hard surfaces
(e.g., sidewalk,
driveway) where it cannot be securely fastened.
To Next Page
Loading...
