Cub CB-724e - Default Chapter; Table of Contents

i
1. Introduction.........................................................................................1
2. Getting Started....................................................................................1
2.1 Unpacking and Inspection............................................................1
2.2 Equipment Checklist.....................................................................1
2.3 Printer Parts...................................................................................3
3. Setup....................................................................................................3
3.1 Setting Up the Printer ...................................................................3
3.2 Loading the Ribbon.......................................................................4
3.3 Loading Label Stock.....................................................................5
3.4 External Label Roll Mount Installation (Option) .........................7
3.5 Peel-off Module Installation (Option)...........................................9
3.5.1 Loading the Paper in Peel-off Mode....................................12
3.6 Cutter Module Installation (Option) ...........................................14
3.6.1 Loading Label in Cutter Mode .............................................16
3.7 Instructions to Top Cover Operation.........................................17
3.8 Diagnostic Tool ...........................................................................20
3.8.1 Start the Diagnostic Tool......................................................20
3.8.2 Printer Function (Calibrate sensor, Ethernet setup, RTC
setup………)...................................................................................21
3.9 Install Memory Card....................................................................22
4. Power on Utilities..............................................................................24
4.1 Ribbon and Gap/Black Mark Sensor Calibration......................24
4.2 Gap/Black Mark Calibration；Self-test；Dump Mode..............25
4.3 Printer Initialization.....................................................................28
4.4 Black Mark Sensor Calibration ..................................................29
4.5 Gap Sensor Calibration ..............................................................29
4.6 Skip AUTO.BAS...........................................................................29
5. Maintenance......................................................................................31
5.1 Cleaning.......................................................................................31
6. Troubleshooting................................................................................33
6.1 LED Status...................................................................................33
6.2 Print Quality.................................................................................34
7. LED and Button Operation...............................................................36
7.1 LED...............................................................................................36
7.2 Button Operation.........................................................................36
Contents