28
4.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Press down and hold the feed button while turning on the printer's power switch.
3. Release the feed button when the LED begins blinking green. (The printer will blink
green 5 times).
The LED color will be changed as following:
Amber Æ red (5 blinks) Æ amber (5 blinks) Æ green (5 blinks) Æ green/amber
(5 blinks) Æ red/amber (5 blinks) Æ solid green
Printer configuration will be restore to defaults as below after initialization.
Parameter Default setting
Speed CB-724e Series, 127 mm/sec (5 ips)
CB-534e Series, 76 mm/sec (3 ips)
Density 8
Label Width 4” (101.6 mm)
Label Height 4” (101.6 mm)
Sensor Type Gap sensor
Gap Setting 0.12” (3.0 mm)
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Cutter Mode Off
Serial Port Settings
9600 bps, none parity,
8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
IP Address DHCP
Note：
Always perform the gap/black mark sensor calibration after printer initialization.
To Next Page
Loading...