EasyManua.ls Logo

Cub SENSOR AID - FCC Statement; FCC Compliance Limits for Class B Device; Interference Correction Measures; IC Statement

Cub SENSOR AID
21 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
FCC
Statement
This
equipment
has been tested and found to comply with the Iimits for a
Class
B digital
device, pursuant to Part 15 of the
FCC R
ules.
These Iimits are
designed
to provide
reasonable
protection
against
harmful
interference in a
residential
installation. This
equipment
generates, uses and can radiate radio
frequency
energy and, if not installed
and used in accordance with the
instructions, may
cause harmful interference to radio
communications.
However,
there is
no
guarantee that interference will not occur in a
particular installation.
lf
this
equipment
does cause
harmful
interference to radio or
television
reception,
which can be
determined
by
turning
the
equipment
off and on,
the user is
encouraged to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving
antenna.
lncrease the separation between the
equipment
and receiver.
Connect the
equipment
into an outlet on a circuit different from that to
which
the receiver is
connected.
Consult the dealer or an experienced
radio/TV
technician for
help.
IC
Statement
The
requirement
is specified in
RSS-GEN
Section 5.3. This device complies with
Industry
Canada license-exempt RSS standard(s). Operation is subject to
the
following
two
conditions:
(1) this device may not cause interference, and (2)
this
device must
accept any interference, including
interference that may
cause
undesired operation of
the
device.
CE
Compliance
Notice
Disposal of Waste Electrical & Electronic
Equipment
CUB
ELECPARTS
INC
No.6, Lane 546,
Sec.
6, Chang Lu
Rd.,
Fuhsin
Hsiang,Chang
Hua County, Taiwan
http:/
/www.cubautoparts.com
To obtain repair or replacement of the product under warranty, or
general
inquiries, assistance, please refer to CUB
information
card to contact our
local
distri
butor.
21
All
CE
marked CUB sensor products are in
compliance
with the
essential requirements and other relevant provisions of Directive
1999/5/EC. A copy of the Declaration of Conformance will be
provided upon request.
This mark on a product and/or accompanying documents
indicates
t
hat this product complies with the EU Directive
2002/96/EC and that when it is to be disposed of, it must be
treated as Waste Electrical &
Electronic Equipment (WEEE).