16 Culligan® CSM Series Softeners
16 Cat. No. 01016370
Brine System Installation
NOTE The brine system is purchased as an optional item to allow the dealer to use various brine tank sizes
to better suit the needs of the user.
The CSM system is normally regenerated using a timed brine refill, dry or wet salt storage brine system (See page 55).
To properly install the brine system, locate the brine tank assembly in a convenient location for ease of service and refill of
salt into the brine tank.
The piping from the brine valve within the brine tank and the timed refill controller should be done using 3/4” pipe and
fittings (not included). Plastic pipe is recommended because of its corrosion resistance and ease of installation. Refer to
the layout drawings on page 13.
Brine Piping
The softeners can be used with a variety of brine systems. Please refer to Appendix A, Table 16 on page 94 for sizing
parameters. Position the salt storage tank in a convenient location on a smooth surface.
Overflow
Brine chamber
Brine Valve
Connect 3/4”
pipe to valve.
Figure 14.
To Next Page
Loading...
Need help?
General
