CULLMANN CUlight FR 36 C - Flash Mode: TTL Autoflash; TTL Mode

35
Power Management
Use Power Switch to power the ash unit on (Long press the
button for one second) or off. Turn off if it will not be used for an
extended period of time. Setting as a master ash, it will turn the
power off automatically after a certain period (approx. 90 sec-
onds) of idle use. Pressing the camera shutter halfway or press-
ing any ash button will wake up the ash unit. Setting as a slave
ash, it will enter sleep mode after a certain period (adjustable,
60 minutes by default) of idle use. Pressing any ash button will
wake it up.
C.Fn
Disabling Auto Power Off function is recommended
when the ash is used off camera. (C.Fn-ST, Page 46)
Flash Mode: TTL Autoash
This ash has three ash modes: TTL, Manual (M), and Multi
(Stroboscopic). In TTL mode, the camera and the ash will work
together to calculate the correct exposure for the subject and the
background. In this mode, multiple TTL functions are available:
FEC, HSS, second curtain sync, etc.
* Press < MODE > Mode Selection Button and three ash modes
will display on the LCD panel one by one with each pressing.
TTL Mode
Press < MODE > Mode Selection Button to enter TTL mode. The
LCD panel will display < TTL >.
• Press the camera release button halfway to focus.
• When the shutter button is fully pressed, the ash will re a pre-
ash that the camera will use to calculate exposure and ash
output the instant before the photo is taken.
Display “HI”: When the ash output value is up to the maximum
value, “HI” will be displayed and blinking for 3 seconds. Adjust
the camera’s parameters if underexposure appears.
Display “Lo”: When the ash output value is up to the minimum
value, “Lo” will be displayed and blinking for 3 seconds. Adjust
the camera’s parameters if overexposure appears.