CULLMANN CUlight FR 36 C - FEC: Flash Exposure Compensation; High-Speed Sync; Second-Curtain Sync

36
FEC: Flash Exposure Compensation
With FEC function, this ash can adjust from -3 to +3 in 1/3rd
stops. It is useful in situations where minor adjusting of the TTL
system is needed based on the environment.
Setting FEC:
1
Press the SET Button and
the ash exposure compen-
sation amount will be high-
lighted on the LCD panel.
2
Turn the Select Dial to set
the amount.
• “0.3”means 1/3 step,
“0.7”means 2/3 step.
• To cancel the ash expo-
sure compensation, set
the amount to “+0”.
3
Press < SET > button again
to conrm the setting.
High-Speed Sync
High Speed Sync (FP ash) enables the ash to synchronize with
all camera shutter speeds. This is convenient when you want to
use aperture priority for ll-ash portraits.
Choose the <
> button:
Press the <SYNC> button to turn on high-speed sync function.
• With high-speed sync, the faster the shutter speed, the
shorter the effective ash range.
• Multi ash mode cannot be set in high-speed sync mode.
• Over-temperature protection may be activated after 15
consecutive high-speed sync ashes.
• Try to avoid using high-speed sync ash, which will cut
short ash tube’s lifetime.
Second-Curtain Sync
With a slow shutter speed, you can create a light train following
the subject. The ash res right before the shutter closes.
Press the < SYNC > button then the <
> icon displayed on the
panel. The ash will without second-curtain sync function in the
Multi mode and in the wireless mode.