CULLMANN CUlight FR 60N - i-TTL Wireless Flash Shooting Guide; Automatic Wireless Flash with Single Slave Unit

44
4. i-TTL Fully Automatic Wireless Flash
Shooting
Using Automatic Wireless Flash with a Single Slave Unit
1
Master Unit Setting
• Attach a CUlight FR 60N ash
unit on the camera and set it
as the master ash (Page 43)
• M/A/B/C can be set as TTL
mode independently.
2
Slave Unit Setting
• Set the other camera ash
as the wireless slave Unit.
(Page 43)
• The slave unit can be set as
A/B/C.
3
Check the communication
channel.
• If the master unit and slave
unit(s) are set to a different
channel, set them to the
same channel. (Page 43)
4
Position the camera and
ashes.
• Position the camera and
ashes as the picture shows.
(Page 42)
5
Check that the ash is ready.
• Check that the master ash
ready indicator is lightened.
• When the slave ash ready
indicator is ready, the AF-as-
sist beam lighting area will
blinks at 1 second intervals.
6
Check the ash operation.
• Press the master unit’s Test
Button <
>.
• Then, the slave unit will re.
If not, adjust the slave unit’s
angle toward the master
unit and distance from the
master unit.
• The slave unit might be out of order or re an unwanted
ash due to the nearby uorescent lamp or computer
screen.
• If the slave unit’s auto power off function is workable,
press the master unit’s test button to power it on. Please
note that test ring is unavailable during the camera’s
regular metering time.
• The effective time of slave auto power off is changeable.
(C.Fn-Sv APOT Page 50)
• By making some settings, the auto AF-assist transmitter
will not blink after the slave unit‘s ash ready indicator is
lightened. (C.Fn-AF Page 50)
R
FR60X_Nikon 171010.indd 44 10.10.2017 17:14:03