CULLMANN CUlight FR 60S - M: Manual Flash

42
M: Manual Flash
The ash output is adjustable from 1/1 full power to 1/128th
power in 1/3rd stop increments. To obtain a correct ash
exposure, use a hand-held ash meter to determine the required
ash output.
1
Press <MODE> button so
thatr <M> is displayed.
2
Turn the Select Dial to
choose a desired ash output
amount.
3
Press <SET> button again to
conrm the setting.
Flash Output Range
The following table makes it easier to see how the stop changes
in terms of f/stop when you increase or decrease the ash
output. For example, when you decrease the ash output to 1/2,
1/2-0.3, or 1/2- 0.7, and then increase the ash output to more
than 1/2, 1/2+0.3, 1/2+0.7, and 1/1 will be displayed.
Figures displayed when reducing ash output level.
Figures displayed when increasing ash output level
Optic S1 Secondary Unit Setting
In M manual ash mode, press <S1/S2> button so that this ash
can function as an optic S1 secondary ash with optic sensor.
With this function, the ash will re synchronously when the
main ash res, the same effect as that by the use of radio
triggers. This helps create multiple lighting effects.
Optic S2 Secondary Unit Setting
Press <S1/S2> button so that this ash can also function as an
optic S2 secondary ash with optic sensor in M manual ash
mode. This is useful when cameras have pre-ash function.
With this function, the ash will ignore a single “preash” from
the main ash and will only re in response to the second, actual
ash from the main unit.
Manual Off Camera High-speed Setting
In M manual ash mode, press <
SYNC
>- button to select high-
speed mode and is displayed.
• S1 and S2 optic triggering is only available in M manual
ash mode.
R
R
616x0_CUlight_FR60X_BDA_Sony englisch.indd 42 24.10.2016 13:59:18