CULLMANN CUlight FR 60S - Setting Master Units Flash Mode; Setting the Communication Channel; TTL: Fully Automatic Wireless Flash Shooting

47
Slave Unit Setting
R
1
Press <R> button so that
< > and < > are
displayed on the LCD panel.
2
The backlight turns orange
now.
2. Setting Master Unit’s Flash Mode
1
Press Function Button 4
<
Gr
> to choose the group
from M/A/B/C. Then, press
Function Button 3 <MODE>
so that the master unit can
work in OFF/TTL/M ash
mode. Choose one of them
as the ash mode of master
unit.
2
Press < > button to
switch to Multi mode.
3. Setting the Communication Channel
If there are other wireless ash systems nearby, you can change
the channel IDs to prevent signal interference. The channel IDs
of the master unit and the slave unit(s) must be set to the same.
1
Press Function Button 3
<
CH
> and turn the Select
Dial to choose a channel ID
from 1 to 32.
2
Press the <SET> button to
conrm.
4. TTL: Fully Automatic Wireless
Flash Shooting
Autoash Shooting with One Slave Unit
1
Master Unit Setting
• Attach a CUlight FR 60S
camera ash on the camera
and set it as the master unit.
(Page 45)
• M/A/B/C can be set as TTL
mode independently.
616x0_CUlight_FR60X_BDA_Sony englisch.indd 47 24.10.2016 13:59:22