CULLMANN CUlight FR 60S - Setting the Communication Channel; Wireless Shooting: 2.4 Ghz Transmission; Wireless Settings

46
3. Setting the Communication Channel
If there are other wireless ash systems nearby, you can change
the channel IDs to prevent signal interference. The channel IDs
of the master unit and the slave unit(s) must be set to the same.
1
Press Function Button 3
<
CH
> and turn the Select
Dial to choose a channel ID
from 1 to 4.
2
Press the <SET> button to
conrm.
• Note: As optical lighting system (WL) is restrained to
Sony’s wireless protocol, there is no much room for CU-
light FR 60S to improve its optical transmission mode.
Therefore, radio transmission (2.4G) is recommended
for its easier operation, creative lighting effects, stable
signals, etc.
Wireless Shooting: 2.4GHz Transmission
• You can set up three slave groups for TTL autoash shooting.
With TTL autoash, you can easily create various lighting
effects.
• Any ash settings for the slave units on the master ash in TTL
mode will be automatically sent to the slave units. So the only
thing you need to do is to set the master unit for each slave
group without any operation for the slave units at all during the
shooting.
• This ash can work in TTL /M /Multi / OFF ash modes when
set as a master unit.
1. Wireless Settings
You can switch between normal ash and wireless ash. For
normal ash shooting, be sure to set the wireless setting to OFF.
Master Unit Setting
• Even with multiple slave units, the master unit can
control all of them via wireless.
• In this user manual, “master unit” refers to the camera
ash on a camera and “slave unit” will be controlled by
the master unit.
1
Press < > button so that
< > is displayed on the
LCD panel. If < MULTI >
mode is ON.
2
The backlight turns green
now.
R
616x0_CUlight_FR60X_BDA_Sony englisch.indd 46 24.10.2016 13:59:20