10
INSTRUCTIONS FOR THE INSTALLER
The gas, water, electrical systems and the rooms where the equipment will be installed must comply with
the safety, accident prevention and fire prevention standards applicable in the country of use; otherwise
the Manufacturer shall not be liable for any direct or indirect damage to people or property.
ATTENTION! Always shut off the main electric switch when installing, servicing or repairing the equipment.
Before making the electrical connection, make sure that the voltage and frequency stated on the
specifications plate corresponds to those of the power supply.
A circuit breaker with auto-protection and sufficient capacity must be installed upstream of the equipment; it
must have a contact opening distance that permits complete disconnection. (the specifications regarding the
opening distance of the contacts and the maximum leakage current must be taken from current regulations).
The equipment must be earth bonded.
The equipment must also be connected to an equipotential system using the screw located at the back of the
equipment, to the lower left, marked with the symbol
This equipotential system must comply with current standards.
Install the equipment in a well ventilated area, as incorrect air recirculation impedes optimal operation and
the “wellbeing” of the people working near the equipment. Do not obstruct the ventilation system in the
area where the equipment is installed.
Do not obstruct the ventilation and exhaust holes in this or any other equipment. At the end of installation,
dispose of the packaging pursuant to local ecological and environmental regulations.
The material used for packaging is compatible with the environment and can be kept safely or burnt in a
specific waste combustion system. The plastic components subject to disposal with recycling are marked
with this symbol
To Next Page
