19
USE
Wait until the plates have reached the set temperature; attempt
to flatten a few balls by varying the plate distance using the lever
(13) up until the desired depth has been achieved.
Flattening is achieved by positioning the dough ball at the
center of the bottom plate and keeping the protection grille
(14) lowered.
Once the bottom plate has returned to the original position,
the protection grille can be raised and the dough disk can be
removed taking care not to burn yourself on the plate surface.
Find the setting most suited to the type of dough used; the
machine is ready to begin operating.
SHUTTING OFF
To switch the machine off simply press the ON/OFF key (11).
ATTENTION: The protective grille must only be raised when
the lower plate has finished the levelling cycle and has
returned to the original position; should you wish to lower
the bottom plate beforehand to reduce the diameter of the
disk plate, raise the grille before the end of the cycle.
To Next Page
