CABLE PULLING BASICS
Model 88 Cable Puller and Accessories
The Model 88 Cable Puller has a maximum pulling force of 8,000 lbs.
Therefore, all of the accessories used to make a cable pull with this unit
must
be rated to meet or exceed the forces generated. This includes, but
is not limited to pulling rope, sheaves, swivels, grips, etc. Be aware that
the pulling force on a sheave and its anchoring system can be as great as
twice the pulling force generated by the cable puller.
Power Requirements
The Model 88 Cable Puller motor is rated at 120 volt – 60 hz – 15 amps.
10
ALWAYS plu
the Model 88 Cable Puller into a
rounded receptacle with
a 15 am
GFCI
rotected circuit
DO NOT modif
the plug provided with the Model 88 Cable Puller. If needed
have a 15 amp GFCI receptacle installed b
a qualified electrician
ARNIN
If an extension cord is used, it should be a minimum of 12
au
e wire with
round and a maximum len
th of 100 ft
UTI
Do NOT exceed load ratin
of cable puller, rope, or accessories.
ARNIN
Inspect all components of the pulling s
stem before beginning an
cable pulling.
This includes the cable puller and an
accessorie
sheaves, swivels. etc.
Replace an
worn or defective components
UTI
To Next Page
Loading...