This manual should be read and understood by all personnel who operate or service
this Cable Puller or any component of the Cable Pulling Package. Failure to understand
equipment should only be operated and serviced by qualified personnel.
RETAIN SAFETY INFORMATION
4
Do NOT operate cable puller in wet or damp locations.
Do NOT expose to rain.
Do NOT operate in an explosive atmosphere.
Do NOT use cable puller as a hoist or for lifting, supporting
or transporting people or loads. Use only for its intended
purpose as a cable puller.
Do NOT wrap rope around any body parts. Do NOT wrap
rope around wrists.
ALWAYS keep rope away from operator’s feet.
Do NOT exceed load rating of cable puller, rope, or accessories.
ALWAYS inspect rope before each use.
ALWAYS disconnect cable puller before servicing.
ALWAYS plug the Model 88 Cable Puller into a grounded
receptacle with a 15 amp GFCI protected circuit. Do NOT
modify the plug provided with the Model 88 Cable Puller.
ALWAYS inspect the structural integrity of any supports,
conduit, anchoring system etc. that will hold the cable puller
during the pull. These supports should be able to withstand
the maximum pulling force of the cable puller plus a safety
factor of 3:1.
Example: 8,000 lb. puller should be anchored
to a support that can withstand 24,000 lbs. of pull
.
IMPORTANT SAFETY INFORMATION
secured before operating.
To Next Page
Loading...
Need help?
General