Current Tools 8845 - Page 12

ALWAYS insure cable puller is properl
y
secured before operating.
ALWAYS attach to su
pp
orts that are at least 2" and not more than the 10" wide
.
OK
T
OO
WID
E
DAN
G
ER
12
A
D
C
B
Figure 5
A– Loosen the mounting chain
handle so that only 3 or 4 threads
remain engaged.
B– Wrap the chain around the
floor mount, conduit or structural
support sufficient to handle
the pulling forces.
C– Pull the loose end of the mounting
chain tight and hook the closest
chain link into the recessed area.
D– Tighten the chain handle.
Repeat this process for second
mounting chain.
Be sure threads do not bottom out before chain becomes ti
g
ht.
W
ARNIN
G
CABLE PULLING BASICS continued . . .