Current Tools 8845 - Page 6

Some components of the cable pulling package exceed 50 lbs.
and will require more than one person to lift, transport, and
assemble.
ALWAYS inspect pins to be sure they are fully inserted through
holes and have spring clips properly attached.Do NOT substitute
any other object for factory supplied pins.
Do NOT mount the Model 88 Cable Puller to square columns
or I-beams. The mounting chains will not tighten properly on
these structures.
The ONLY approved method to secure the Model 88 Cable Puller
is with the 2 mounting chains provided. Do NOT attempt to use
any other object to secure the cable puller.
Inspect mounting chains for wear before each installation.
NEVER alter the mounting chains or handle.
When making a vertical cable pull, keep the area underneath
the cable pull clear of all personnel.
Do NOT alter this cable puller. Doing so will void the warranty.
Guards and safety features are provided for your protection.
Do NOT use an extension cord longer than 100 ft. Extension
cord should be a minimum of 12 gauge wire with ground.
6
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
CAUTION
CAUTION
IMPORTANT SAFETY INFORMATION continued . . .
FI
GU
RE 2
A
FI
GU
RE 2
B
N
O
OK
Never ti
g
hten chain as shown in Fi
g
ure 2A. This causes side loadin
g
of the chain and can result in failure of the chain or screw causin
g
components to come loose and possibl
y
cause serious in
j
ur
y
or
death. Fi
g
ure 2B shows the proper ali
g
nment of screw and chain
for ti
g
htenin
g
.
W
ARNIN
G
Figure 2BFigure 2A