Curt Manufacturing REFLEX - Key Features

PAGE 2
This package includes:
(1) Brake control module with quick plug
(1) Slide-in mounting bracket
(2) Mounting bracket screws
(1) Double-sided mounting tape
(1) Surface prep wipe
(1) Quick reference card
One or more of the following may be needed to complete installation:
•
Brake control connection harness, supplied with the tow vehicle (if equipped)
•
CURT quick plug - custom connector for specic vehicles. See catalog for availability
•
CURT part# 51515/51516 - male quick plug with pigtails
•
CURT part# 51500 - brake control wiring kit
Key Features
•Polarityprotectedagainstpositiveandnegativepowerreversal
•Powerconservationmodeafteronehourofinactivity,wakeswhenbrakepedalispushed
•Displayiscapableofcommunicatingoperatingerrors
•
Manual control lever activates brake lights
•
Reduced output when sitting still (railroad crossing, stoplight, etc…)
•
Will work with most electrically activated hydraulic trailer brake systems
•
Nearly unlimited mounting positions, single calibration upon initial setup