INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
3. Using a hammer, flatten the tabs on the end of the bumper beam
assembly so they are flush.
4. Unclip the wiring from the ends of the fascia clips and unclip the lower
fascia from the rest of the bumper cover to remove.
5. Raise the hitch and bumper beam assembly into position and loosely
install fasteners with a 13mm socket.
6. Torque all M8 fasteners to 23 lb-ft.
7. Re-install lower bumper fascia in reverse order of removal.
8. Using the diagrams below, trim the underbody panels as needed for
reinstallation.
9. Reinstall the remaining underbody panels removed in step 1.
To Next Page
Loading...
