PAGE 9
•
51126-INS-RA
•
PRODUCT SUPPORT: 877.287.8634
•
CURTMFG.COM
• The gain adjustment is the orange rocker
switch (#3) on the left of the controller
• Adjusting the gain
- Upper rocker switch increases
power level to the brakes
- Lower rocker switch decreases
power level to the brakes
• After 10 seconds of no user input,
the interface will switch to sleep mode
and the display will go to sleep
Gain
GAIN CONTROL (LEFT SIDE OF DISPLAY - FARTHEST LEFT)
The gain control establishes the maximum amount of power
available to the trailer brakes when braking. The only exception
would be when the manual control is set up for 100% braking.
The gain control can be adjusted during initial setup
or anytime when trailer load changes and adjustment
is needed for changing road or driving conditions.
• Shows output power from 0.5 to 9.9 when
the vehicles brakes are being applied
• After gain and load have been adjusted, this will
show the amount of power to the trailer over time
- The gain is an amount of power to the
trailer based on the operator's settings
- The load is the amount of time needed to stop
the trailer based on the operator's settings
• The control adjustment is the black rocker
switch just to the left of the display (#2)
- Upper rocker switch increases brake aggressiveness
- Lower rocker switch decreases brake aggressiveness
• 1 to 9 scale
Auto - output
power over
time as brakes
are applied
Load Sensitivity
- trailer brake
aggressiveness
AUTO (SHOWS OUTPUT FROM CONTROL TO TRAILER BRAKES)
LOAD CONTROL (LEFT SIDE OF DISPLAY - RIGHT SWITCH)
The load control adjusts the trailer brake aggressiveness.
Load adjustment has no effect on the manual control.
The load control can be adjusted for individual driver
preference, trailer load changes or changing road conditions.
To Next Page
Loading...
Need help?
General
