B. Mounting the new controller:
1. Using a rag and cleaner, clear any debris from
the thermal pad to maximize thermal transfer.
2. Using the original controllers mounting bolts
and holes mount the conversion plate to the
vehicle heatsink.
3. Using a small scraper or razor blade, spread
the three tubes of thermal compound (included)
evenly over the new controllers heatsink.
4. Using the four M6 bolts, washers, and lock
washers (included) securely mount the new
controller to the adapter plate previously installed.
62-EZHB-AO WORK INSTRUCTIONS REV. 02 9/14/2018
To Next Page
Loading...
