To Next PageTo Next Page
Need help?Do you have a question about the Curtis 1244 and is the answer not in the manual?
General| Brand | Curtis |
|---|---|
| Model | 1244 |
| Category | Controller |
| Language | English |
Details controller dimensions, mounting positions, and environmental protection considerations.
Details low current and high current connector pin assignments and types.
Illustrates typical power and control wiring configuration for standard applications.
Details wiring for input switches, contactors, and specific pin functions.
Explains wiring for various throttle types, including 5kΩ-0, 0-5V, and CAN-Nodes.
Describes the use of fault output drivers for diagnostic information to displays.
Details controller drivers for main, auxiliary, reverse, and electromagnetic brake contactors.
Covers essential external components like main contactors, keyswitches, and pedal switches.
Defines parameters for acceleration rate, braking rate, deceleration, and quick start.
Covers settings for maximum speed, creep speed, and regenerative braking speed thresholds.
Details control modes, throttle types, deadband, maximum throttle, and throttle maps.
Explains parameters for drive, braking, field current limits, and restraint.
Discusses High Pedal Disable (HPD), Static Return to Off (SRO), and fault code configurations.
Covers parameters for contactor driver interlocks, delays, checks, and output statuses.
Includes settings for battery voltage, anti-tiedown, sequencing delay, and emergency reverse.
Allows disabling MultiMode™ for single-mode operation or configuring individual parameters.
Enables auxiliary, reverse signal, and electromagnetic brake drivers as a group.
Configures the controller for use with CAN-based communication systems.
Identifies the four primary characteristics for tuning vehicle performance: throttle range, motor, top speed, and load equalization.
Procedures to set Throttle Deadband and Throttle Max for optimal throttle input response.
Steps to match controller parameters to motor specs for maximized performance and protection.
Guides for adjusting Field Min and Max Speed parameters to set desired unloaded top speed.
Explains using Field Map Start and Load Compensation to match loaded and unloaded vehicle speeds.
Covers adjustments for throttle response, direction transitions, ramp climbing, and ramp restraint.
Lists all programmable parameters accessible via the programmer, categorized by function.
Displays real-time operational values for inputs, outputs, and system status.
Provides a list of diagnostic messages, fault codes, and troubleshooting information.
Explains how to use the programmer's menus for fault diagnosis and troubleshooting.
Details how the controller's Status LED indicates fault codes through flashing patterns.
Describes how fault output pins provide diagnostic information to external displays.
Provides instructions for safely cleaning the controller exterior to prevent corrosion.
Explains how to access, interpret, and clear the controller's logged fault history.
