Curtis 1244 - Acceleration Parameters

24
Curtis 1244 Manual, Rev. E
3 — PROGRAMMABLE PARAMETERS
e programmable parameters are described in the following order. ey
are listed in the text by the abbreviated names that are displayed by the pro-
grammer. Not all of these parameters are displayed on all controllers; the list
for any given controller depends on its specifications.
ere are additional parameters that can only be configured at the factory.
e manufacturer can specify how these parameters will be configured, but they
are not programmable using the programmer. See Section 4: OEM Specified,
Factory Set Parameters.
Acceleration Parameters
Acceleration Rate, M1–M4
Braking Rate, M1–M4
Deceleration Rate
Quick Start
Taper Rate
Speed Parameters
Maximum Speed, M1–M4
Creep Speed, M1–M4
Regen Speed
rottle Parameters
Control Mode
rottle Type
rottle Deadband
rottle Maximum
rottle Map, M1–M4
rottle Braking Percent, M1–M4
Current Limit Parameters
Drive Current Limit, M1–M4
Braking Current Limit, M1–M4
Minimum Field Current Limit
Maximum Field Current Limit
Restraint
Emergency Reverse Current Limit
Current Ratio