Curtis 1220 - User Manual

Manual
Model 1220
Electric Steering Controller
for Brushed PM Motor
Read Instructions Carefully!
Specications are subject to change without notice.
© 2015 Curtis Instruments, Inc. ® Curtis is a registered trademark of Curtis Instruments, Inc.
© The design and appearance of the products depicted herein are the copyright of Curtis Instruments, Inc. 53218 Rev C 11/2015
Curtis Instruments, Inc.
200 Kisco Avenue
Mt. Kisco, NY 10549
www.curtisinstruments.com

Summary

OVERVIEW

Advanced Motor Control

Maximum Safety

Safety features and redundancy checks in the controller.

INSTALLATION AND WIRING

MOUNTING THE CONTROLLER

CONNECTIONS: High Current

Details on connecting high current power terminals.

CONTROLLER WIRING

Wiring diagrams and explanations for connecting the controller.

INPUT;OUTPUT SIGNAL SPECIFICATIONS

Electrical characteristics of controller input and output signals.

PROGRAMMABLE PARAMETERS

COMMISSIONING

Preparation for commissioning

Command Map setup

Configuring the steering input to output mapping.

Command Input Device setup

Setting up the primary and redundant steering command inputs.

Position Feedback Device Setup

Configuring the selected position feedback sensor.

DIAGNOSTICS & TROUBLESHOOTING

TROUBLESHOOTING CHART

Comprehensive list of faults, causes, and actions.

MAINTENANCE

Curtis 1220 Specifications

General

Brand	Curtis
Model	1220
Category	Controller
Language	English