Curtis Alpha FreshTrac G3 Series - Page 12

FreshTrac Receiver Removal
The FreshTrac receiver can be removed from the decanter
when it needs to be replaced due to the battery expiring or
EVFUPUIFEFDBOUFSCSFBLJOH
1 'PSTBGFUZMBZBUPXFMPVUPOUPQPGBEFTLPS
countertop and place the decanter on top.
2 Remove the receiver by pressing down on the edge of
UIFDMJQXIFSFJUIPPLTPOUPUIFIBOEMF5IFSFDFJWFS
TIPVMEDPNFPGGXJUImOHFSQSFTTVSF
FreshTrac Receiver Installation
The FreshTrac receiver attaches to the left side of the
decanter. It is held in place on the decanter by a pin and
BDMJQXJUIBTOBQFEHF.BLFTVSFUIBUUIFSFQMBDFNFOU
Curtis decanter is FreshTrac compatible (has a hole in the
handle).
1 Position the receiver into the recessed area of the
handle as shown.
2 Press the receiver into the handle to attach. The
receiver should snap into place.
3 Position the decanter on an Alpha FreshTrac brewer
BOESVOBUFTUCSFXUPNBLFTVSFUIFSFDFJWFSPQFSBUFT
OPSNBMMZ7FSJGZUIBUUIF'SFTI5SBDSFDFJWFSnBTIFTmWF
times when the BREW button is pressed. See Using the
FreshTrac Timer on the previous page for more details.
OPERATING INSTRUCTIONS OI26
ALPHA FRESHTRAC, OPERATING INSTRUCTIONS 100317NC
WARNING: "WPJE CFJOH DVU CZ CSPLFO HMBTT *G
SFNPWJOHUIFSFDFJWFSGSPNBCSPLFOEFDBOUFSVTFB
IBNNFS PS QMJFST UP LOPDL MPPTF BOZ SFNBJOJOH
glass shards still attached to the handle before
removing the receiver.
WARNING: Avoid using metal tools when installing
the receiver. Do not use excessive force to press the
receiver onto the handle.
Do not dispose of the FreshTrac receiver in an
ordinary trash container. Contact you local
municipality to determine acceptable procedures
for disposal of electronic waste.
FreshTrac
receiver.
FreshTrac
receiver
Press down
on edge of
clip to remove
FreshTrac
receiver