Curtis CBS - Sanitizing Disassembled Parts; Cleaning Airpots and Precautions; Liquid Level Probe Cleaning

9
To sanitize the disassembled parts:
Wear rubber gloves for protection.
1.Placethecleanedpartsintoasink.
2. ImmersethemincommercialBarTabs/Sani-TabssanitizingsolutionThesolutionmustbewarm(75°F.)Allowthepartssoakinthesanitizerforat
least one minute.
3. Removethepartsfromthesanitizerandairdry.
4.Aftercleaning,sanitizinganddrying,assemblethepartstakenfromtheteacontainer.
Cleaning Airpots:
1. Inacontainer,mixamilddetergentsolutionforcleaningyourairpots.
2. Discardanyoldcoffeefromtheairpot.
2. Wipetheexteriorsurfaceswithaspongemoistenedwiththedetergentsolution,removing
waterspotsandcoffee.
3. Removeandcleanthesyphontube/funnelwithadetergentsolution.
3. Cleaninsidetheairpotswithaspongebrushsoakedindetergentsolution.
4. Aneasywaytocleanremovemineraldepositsfromthebrewconeandairpot,istouse
coffeeequipmentcleaningtablets.
 a.Placeatabletintothebrewcone.
 b.Placetheairpotontothebrewdeckandopenthelid.
 c.StartacoffeebrewcyclebypressingtheBrewbuttononthecontrolpanel.
 c.Oncethebrewcyclehasnished,allowthecleaningsolutiontositintheairpotfora
 minute.Discardtheusedcleanerfromtheairpot.
 d.Rinsetheairpotandbrewconewithrunningwater.Boththebrewconeandairpotshouldbecleanandreadytouse.
Airpot Precautions:
 Donotimmerseairpotsinwater.
 Donotplaceindishwasher.
 Donotuseharshpowdersorcleanserscontainingchlorine.
 Donotuseawirebrushorpotscourtocleaninsideliner.
Liquid Level Probe
Cleaningintervalsfortheprobearetobedeterminedbytheuserortheservicetechbasedonwaterconditions.Theuseofwaterlters,orthetype
ofwaterlterthatisbeingusedcanimpacttheserviceinterval.Intervalscanbefromonemonthtoseveralyears,however,replacingratherthan
cleaning the probe is preferable.
WARNING:Disconnectelectricalpowerbeforeremovingaccesspanels!
CAUTION: Thisprocedureinvolvesworkingwithhotwaterandhotsurfaces!
1. Unplugthepowercordandshutoffthewaterline.
2. Removethetopcoveroftheunit.Locatethetopofthetankandremovethecover.
3. Drainthetanktoalevelabout3”belowthetipoftheprobe.
4. Allowsometimefortheprobetocoolbeforeworkingonthebrewer.
5. CleanthetipoftheprobeusingaScotch-Brite
TM
scuff pad.
6. Ifaresidualwhitelayerisstillvisibleontheprobe,removetheprobeandsoakitinvinegarorascaleremovingchemical.Repeatthisstepuntil
thewhitelayerisremoved.