OPERATING INSTRUCTIONS OI17
(&.44(&.5401&3"5*/(*/4536$5*0/4øø "
Brewing Instructions
Place an empty satellite
under the brew basket. Make
sure the satellite is pushed
all the way back against the
front cover.
3 *OTFSUBDMFBOQBQFSmMUFSJOUP
the brew basket.
4 Fill with the proper amount
of ground coffee. Level the
DPGGFFJOUIFmMUFS
5 4MJEFUIFmMMFECSFXCBTLFU
into the brew rails under the
control panel. Slide it all the
way back until it stops.
The brewer will brew coffee or tea based on the settings programmed into the universal control module (UCM). To
change the settings, see the PROGRAMMING GUIDE section. When brewing starts, the warmer will come on. Press
the warmer button to turn the warmer off without turning off the brewer.
The brewer should be ON.
$POmSNUIJTBUUIFSFBSUPHHMF
switch. “Ready to brew”
should be on the display. If
the brewer is connected to an
inter-lock grinder, the grinder
should be on. When inter-lock
connection is made, grind
coffee at this time.
6 Press the brew button. Brewing
will begin immediately.
WARNING - TO AVOID SCALDING, AVOID SPLASHING. Keep body parts clear of the brewer during
brewing. Do not remove the brew basket while “Brewing” appears on the display.
NOTICE - Do not use IntelliFresh satellites on non-IntelliFresh brewers.
The G3 Gemini brewer is factory preset for optimal performance.
To Next Page
Loading...
Need help?
General
