Curtiss-Wright GT200 - Figure 2-5 GT200 PCI Faceplate; Figure 2-6 GT200 PMC Faceplate; Firmware Dependencies; LED Descriptions

PRODUCT OVERVIEW
2.3.6 Firmware Dependencies
The specifications and features described in this manual are based on firmware revisions
at the time of publication. Performance may vary between firmware revisions. Please
contact Technical Support for more information.
2.3.7 LED Descriptions
Three sets of status LEDs are visible from the front panel of the GT200 board. The
position of the LEDs is shown in Figure 2-5 for PCI and Figure 2-6 for PMC.
Link Select (LS)
The Link Select LED indicates which channel of the GT200 board is selected. When the
LED is off, channel 0 is selected. When the LED is on, channel 1 is selected.
Link Up (LU)
The Link Up LED turns on when the selected channel is receiving a valid GT200 signal.
Signal Detect (R0, R1)
The Signal Detect LEDs indicate a signal is being received by the corresponding
transceiver.
Laser Enable (T0, T1)
The Laser Enable LEDs indicate the corresponding transceiver is turned on.
Figure 2-5 GT200 PCI Faceplate
Figure 2-6 GT200 PMC Faceplate
Copyright 2005 2-5 GT200 Hardware Reference