P 190
15
2.7 MAINTENANCE
Changing the paper roll
To change the paper roll, proceed as follows:
1) open the top of the printer and place the paper roll in position, following the arrow, as indicated in
figure 5;
2) insert the end of the roll in the slit (A) of the print mechanism;
3) press the FEED key (B) so that a few centimetres of paper come out of the printer;
4) insert the end into the slit on the top of the printer and close it.
FIGURE 5
Changing the ribbon. Proceed as follows:
1) open the top of the printer and remove the old ribbon cartridge, by pressing down at point (C), as
shown in figure 5;
2) insert the new ribbon, making sure that it is correctly positioned;
3) pull the ribbon tight by turning the knurled knob (D) and close the top down again.
INSTALLATION and USE
To Next Page
Loading...
